1-800-234-3280

Welcome to Steiner Tractor Parts

    1 - 24 of 61 Products >
  1. 3 Point Kit
  2. >
  3. all

3 Point Kit

Sort by:
View: Show: per page
Showing Products: 1 - 24 Total Products: 61

Cinco de Tractor - Antique Tractor Blog

…loved tractors.  After being discharged from the USAF and then working for the Air Force at Hill AFB as a civilian I took up residence in West Point, Utah I found my first tractor, a 1949 Farmall H sitting just up the street by an old barn…  It had a tree growing up between the frame and…

3-Point Hitch Kit

…MTA (diesel), 300, 330, 340, 350, 400, 450, 460, 504, 544, 560, 606, 656, 666, 686 This 3-point hitch kit fits Rowcrops and Utilities without fast hitch. It also allows use of original draw bar. Kit includes (Cat # 1 on tractor end & Cat # 2 on equipment end, and 2 hydraulic 2 way…

Product Number: IHS3009
Price: $985.00

3-Point Hitch Kit

…- Fits: [ C, Super C, 200, 230 (without fast hitch) ] * This 3-point hitch kit is a Cat # 1. Includes brackets to clamp to the axle housing and Cat #1 top link,  Also includes rods and chains for cultivator lift.* If the 3pt drawbar is needed order # FDS022 (sold separately).

Product Number: IHS3014
Price: $750.00

Electronic Ignition Conversion Kit, 6 volt positive ground

…Replaces the points and condenser with an electronic module.* Fits distributors with a clip held cap.* Clockwise rotation* Precisely engineered solid state electronics.* Increase spark life and horsepower with a hotter spark to ignite todays fuels.* Never change points again.* Easy installation;…

Product Number: EIGN01
Price: $149.99

Stabilizer Kit, Category 1

…- Fits: [ Super 55, 550 ((Bars Only)) ]  * The bars and brackets of this stabilizer kit are coated in red primer.* The bars are Category 1 and are flat bars, not turnbuckles.* The kit includes 2 arms, 2 brackets and the pins.* The arms measure 31-1/2" center to center on the pin…

Product Number: FDS024
Price: $67.99

3 Point Conversion Kit

Allis Chalmers - Fits: D14, D15 (Series I), D17 (Series I and II), WD, WD45 * Category 2* Leave your drawbar on* Bolts onto drawbar* Will fit D15 Series II with no sway block* Will fit D17 Series III with no sway block

Product Number: ACS014
Price: $575.00

3 Point Hitch Conversion Kit

Allis Chalmers - Fits: D14, D15, WD, WD45 * Category 1* Lift arms = 5/8" Thick X 3" Wide* Easy to install and remove* Snap Coupler Drawbar MUST Be Removed To Install* Adjustable Uprights Attach To Snap Couplers (which are not included, or hitch can be bolted to snap couplers)* Top link and top link…

Product Number: ACS011
Price: $440.00

3 Point Hitch Conversion Kit

Allis Chalmers - Fits: D17, D19 * Category 2* Lift arms: 3/4" x 3" steel* Easy to install and remove* Snap coupler drawbar must be removed to install* Adjustable uprights attach to snap couplers (which are not included), or hitch can be bolted to snap couplers.* Top link…

Product Number: ACS012
Price: $485.00

3 Point Hitch Conversion Kit

Allis Chalmers - Fits: D17, D19, 190, 190XT * Category 2* Lift arms = 1" Thick X 3" Wide* Easy to install and remove* Snap Coupler Drawbar MUST Be Removed To Install* Adjustable Uprights Attach To Snap Couplers (which are not included, or hitch can be bolted to snap couplers)* Top link and top link…

Product Number: ACS013
Price: $485.00

3 Point Hitch Conversion Kit

Allis Chalmers - Fits: B, C * Category I* Complete with 2" x 8" hydraulic cylinder, shortened adjustable top link and bracket* Tractor MUST have hydraulics to use this conversion* Bolts onto drawbar

Product Number: ACS015
Price: $580.00

Original Style 3 Point Hitch Kit (fits John Deere 720, 730)

Fits John Deere - 720, 730 Kit includes: (2) - adjustable uprights (JDS221), (1) - LH lower lift arm (JDS246L), (1) - RH lower lift arm (JDS246R), (1) - LH elephant ear (JDS551), (1) - RH elelphant ear (JDS553), (1) - top link (JDS117), (1) - LH sway block (JDS087), (1) - RH sway block (JDS086), (4)…

Product Number: JDS1424
Price: $1695.00

Magneto Point Set

…350, 400, 404, 424, 444, 450, 505, 600, 650 (with IH 353898R11 DISTRIBUTOR) ], Cub (with J4 MAGNETO or IH 353898R11 DISTRIBUTOR), Cub LoBoy: Cub Loboy (with J4 MAGNETO or IH 353898R11 DISTRIBUTOR); Replaces: 353172R91 * Point Gap = 0.013"* Fits IHC J4 magneto and IH 353898R1 distributors

Product Number: J4 POINTS
Price: $7.55

Ignition Tune Up Kit

…3550, 420, 420, 4400, 445, 4500, 515, 530A, 531, 535, 540, 540A, 545, 550, 555, 555A, 555B (Fits the following 3 cylinder models from 1965 - 1980) ] * Fits 3 cylinder engines 1965-82* Kit includes:* Points* Condenser* Rotor* (3) Autolite 405 spark plugs* Spark plug and point gap = 0.025"

Product Number: FDS420
Price: $31.25
Related Products: Ford 3400 | Ford 2000 3 Cylinder | Ford 3000

IHC H4 Magneto Point Set

…300, 350, 400, 450, 600, 650 (Some, with H4 magneto) ], Super MTA (Diesel, Some, with H4 magneto), [ Wheatland: 400, 450 (Some, with H4 magneto) ]; Replaces: 21388DBX, 21388DBX-1, 21388DBX-6, 21409DB, 353171R1, 353171R91, 47431DA-1, 47431DB, 47431DB-6, 71455C91 * Point gap for H4 is 0.013"

Product Number: IHS3528
Price: $6.95
Related Products: Ihs3528 | H4 Magneto | Farmall H Points

Ignition Tune-Up Kit

… DELCO distributors only* Spark Plug Dimensions:  7/8" - 18 Thread w/  5/8" Reach, 15/16" Hex*  Kit contains: Rotor, Points, Condenser, And Spark Plugs * Spark Plug Gap = .030"* Point Gap = .020"* Will NOT fit magneto ignitions.

Product Number: JDS267
Price: $24.95

Ignition Tune-Up Kit

…only* Spark plug dimensions: 18 MM, 1/2" Reach 7/8" Hex * Kit contains: Rotor, Points, Condenser, (2) Spark Plugs* Spark Plug Gap = (A thru G: 0.030" Gap), (50 thru 730: 0.025" Gap)* Point Gap = 0.020"* Will NOT fit magneto ignitions. 

Product Number: JDS268
Price: $16.75

Drawbar Check Chain Kit

…TEA20, TO20, TO30 (When using FDS383 and FDS386 lift arms) ] Our sway chain kit includes:* Left hand sway chain anchor* Right hand sway chain anchor* (2) sway chains* (4) clevises* (2) eye bolts ABC302Our FDS274 drawbar check chain kit is designed to fit our FDS383 and FDS386 lift arms.

Product Number: FDS274
Price: $47.75

Ignition Tune-Up Kit

…Distributor w/ 3 3/8" O.D. Cap), 406 (Using AUTOLITE IAD-6004-2E Distributor w/ 3 3/8" O.D. Cap) Minneapolis Moline - Fits: [ Avery: BF, BG, V (Some, Using AUTOLITE IAD-4010-A, IAD-4010-C, IAD-4023 Distributor w/ 3 3/8" O.D. Cap) ] Also Fits Earthmaster Model C & CH. Kit contains: Points and…

Product Number: ABC328
Price: $11.30

Eyelet Assembly Kit

Ford - Fits: [ Golden Jubilee, Jubilee, NAA, NAB, 2000 4 cylinder, 2031, 2100, 2111, 2121, 2131, 2300, 2310, 2N, 3000, 3110, 3120, 3300, 3330, 4000 4 cylinder, 4031, 4100, 4110, 4120, 4121, 4131, 4140, 501, 541, 600, 601, 611, 620, 621, 630, 631, 640, 641, 650, 651, 660, 661, 671, 681, 700, 701,…

Product Number: ABC302
Price: $7.95

Ignition Tune-Up Kit

…with screw held cap.* Fits MM with Delco Remy distributor numbers 1112642, 1112643 and 1112671. Kit contains: Heavy duty point set, vibration resistant condenser and rotor. Point Gaps vary by applications, see chart below:* .016" (Allis Chalmers models)* .022" (John Deere tractor models)*…

Product Number: ABC333
Price: $12.50

Electronic Ignition Conversion Kit

…- Fits: [ MF20, MF40, 2200, 2500 (Perkins 3 cylinder w/ Delco # 1112457 distributor) ] Massey Ferguson - Fits: [ 135, 150 (Perkins 3 cylinder w/ Delco # 1112457 distributor) ] * Fits tractors with 12 volt negative ground system only.* Fits 3 cylinder Perkins applications with Delco…

Product Number: EIGN12
Price: $169.99

Front Mount Distributor Breaker Point Set

Ford - Fits: with front mounted distributor: 2N, 8N (up to SN: 263843), 9N; Replaces: 9N12107, 9N12162, 9N18354, A0NN12107A  * 1939 - 1950

Product Number: FDS3956
Price: $4.99

Drawbar Pivot Pin With Handle, 3 Point Hitch Draft Link Pin

…as a drawbar pivot pin with handle on models Up to SN: 6213099), 70 (3 point only), 800A (Used as a 3 point hitch draft link pin), Industrial Excavator: 800 (Used as a 3 point hitch draft link pin), LIFT KIT: 801 (Used as a 3 point hitch draft link pin), Special (V): 430 (Used as a drawbar pivot pin…

Product Number: JDS1488
Price: $27.00

Vickers Hydraulic Pump Vane-Rotor Kit

…Replaces: 1E4506, 1E4507, 1ES4505, ES4505 Oliver Industrial - Fits: [ 551, 552 (Early, using 1ES2043 1500 Psi square vane hydraulic pump with 5/8" wide vanes) ] * 5/8" wide vanes* Measure before ordering as 2 different sizes could be used* For 3/4" wide vane and rotor kit, see FDS240

Product Number: FDS239
Price: $380.00
Did you find this search useful? Yes No
Sort by:
View: Show: per page