Welcome to Steiner Tractor Parts
Ford - Fits: 8N (SN:263844 and up (1950-52) WITH SIDE MOUNT DISTRIBUTOR) * Fits SN: 263844 and up with side mounted distributor (distributor is mounted to the right side of engine and generator is mounted on left side when sitting on the seat.)
…various models Massey Harris - Fits various models Minneapolis Moline - Fits various models Oliver - Fits various models * This is a universal bracket, it is not a direct bolt on for any application. * It may have to be modified to fit your specific application.* 7/8" wide* 1-1/2" offset* 8-1/4"…
AC Miscellaneous - Fits: Power Unit: W226 (Power unit, SN 96714 and up) Allis Chalmers - Fits: B, C, CA, D10 (Up to SN: 3500), D12 (Up to SN: 3000), D14, IB (SN: 55301 & Up); Replaces: 210990, 70210990 Bare finish. 6.080 O/A length, 1" wide, 0.250 thick. 2 holes = 0.375 O.D. 2 holes = 0.340 O.D.
Allis Chalmers - Fits: B, C, CA, IB (SN: 55301 & up); Replaces: 210989, 70210989
…with FDS389 generator style gauge cluster.* 1/2" wide x 3-3/4" O.D. pulley* Includes: 63 amp. 12-Volt alternator with rear mounted tachometer drive, upper and lower brackets, adapter wire with terminal ends, mounting hardware, and instruction sheet. * Replaces the original Lucas generator.*…
Fits John Deere - H; Replaces: H921R
Massey Ferguson - Fits: TO20, TO30 (Equipped with generator); Replaces: Brackets: 1751311M1, 1751312M1, Tach: 1751314M91
…negative ground. If you decide that conversion isn’t for you and you want to repair an existing generator, check out this bulletin from Delco-Remy regarding service and maintenance of their generators. Farmall / International, Jr.'s Corner, Repair Blog new parts for old tractors, repair blog…
…properly), you’re ready. * What parts do I need? A standard conversion will require an alternator, alternator bracket, battery, coil, wiring harness, and amp gauge. Replace the existing generator and voltage regulator with the alternator, and swap out the old battery, coil, wiring harness, and amp…
…(SN: 263844 & up with side mounted distributor, When Converted To A 12 Volt System, (Distributor is mounted to the right side of engine & generator is mounted on left side ) ); Replaces: C0NF12029A, D5TE12029AB, D8JL12029A Ford Industrial - Fits: [ 1801, 1811, 1821, 1841, 1871, 1881, 4040…
…starter, which is the same as 12 volt regular Cubs. Starter generator was replaced with a Delco alternator. IH offered an update package beginning in sometime the 185 run. It consisted of a gear drive starter, alternator and bracket, and a flywheel ring gear was needed on some models. Starter…